[E140] Lower drawer misfeeding (paper not reaching the 2nd transport sensor)
Classification
Paper misfeeding
Proce
Check item
dure
1
Open the feed cover. Is
there any paper in front of
the 2nd transport sensor?
2
Is the 2nd transport sensor
working?
(Perform the input check
in the test mode: 03-
[FAX]OFF/[7]/[A])
3
Is the lower drawer feed
clutch working?
(Perform the output check
in the test mode: 03-202)
4
Lower drawer feed roller
Separation roller
Pickup roller
Parts to be replaced
2nd transport sensor
LGC board
Lower drawer feed clutch
Lower drawer feed roller
Separation roller
Pickup roller
© 2015 TOSHIBA TEC CORPORATION All rights reserved
Error content
Jam not reaching the 2nd transport sensor
Result
Yes
Remove the paper.
No
Yes
No
•
Check if the connector of the 2nd transport
sensor is disconnected.
•
Check if the connector CN316 on the LGC
board is disconnected.
•
Check if the connector pins are
disconnected and the harnesses are open
circuited.
•
Check if the conductor pattern on the LGC
board is short circuited or open circuited.
•
Replace the 2nd transport sensor.
•
Replace the LGC board.
Yes
No
•
Check if the connector of the lower drawer
feed clutch is disconnected.
•
Check if the connector CN315 on the LGC
board is disconnected.
•
Check if the connector pins are
disconnected and the harnesses are open
circuited.
•
Check if the conductor pattern on the LGC
board is short circuited or open circuited.
•
Replace the lower drawer feed clutch.
•
Replace the LGC board.
•
Check the lower drawer feed roller,
separation roller and pickup roller. Replace
them if they are worn out.
8 - 87
Measure
Remark
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
Next
Step
2
3
8
4