Toshiba e-STUDIO2008A Service Manual page 192

4.5.28 1st drawer empty sensor (S12) and 1st drawer tray-up sensor
(S11)
(1) Remove the 1st drawer paper feed unit.
 P. 4-58 "4.5.14 1st drawer paper feed
unit"
(2) Remove the 2nd drawer paper feed unit.
 P. 4-61 "4.5.16 2nd drawer paper feed
unit"
(3) Remove the tray-up motor units.
 P. 4-68 "4.5.22 Upper tray-up motor unit"
 P. 4-68 "4.5.23 Lower tray-up motor unit"
(4) Release 1 latch.
(5) Feed out the sensor holder [1] to the rear
side, and then remove it.
Notes:
When installing, fix it using the sensor holder
projection [2] and latch [3].
e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
© 2015 TOSHIBA TEC CORPORATION All rights reserved
4 - 72
Fig. 4-196
Fig. 4-197
Fig. 4-198