Configuring Interlocks - Honeywell MPA1 User Manual

2.
Deleting a Site Code
Click

Configuring Interlocks

An interlock is a programmed connection between two points. The interlock causes an
input point, output point, or group of output points to act in a specified manner when
another input point, output point, or group of output points changes its state. An action on
the trigger point causes a reaction on the reacting component. For example, when a motion
detector (input) detects movement, it causes a horn (output) to sound.
On the Interlocks pane, you can:
•
•
1.
The Name and Code fields become active.
Make your modifications, then click the green check mark to save.
A message appears confirming that the new site has been Successfully Updated.
to delete a site code.
Create and delete interlocks.
Enable or disable existing interlocks.
Navigating to the Interlocks interface.
• Click Panel Configuration > Advanced > Interlocks.
Figure 2-33 Interlocks Configuration Tab
Document 800-26311_ A - April 2020
| 63