Hard Default An Existing Secondary Panel (Web Mode); Overview; Primary | Secondary Panel Synchronization (Hard Default) - Honeywell MPA1 User Manual

IMPORTANT: In order to proceed to Step #3 please wait for all panels to be synchronized.
Step # 3. Select the "Restore Entire Loop" option from the "System Wide Backup" once all

Hard Default an Existing Secondary Panel (Web Mode)

Overview

This section details the synchronization process of a MPA1 "Primary | Secondary" panel
after hard defaulting an existing "Secondary" Panel in a loop of Ethernet Virtual Loop (EVL)
in Web Mode.

Primary | Secondary Panel Synchronization (Hard Default)

Step # 1. Perform a System Wide Backup
Step # 2. Perform a hard default of the Secondary panel.
Step # 3. Un-register the original Secondary panel in the Primary panel. Navigate to:
Step # 4. Navigate to the "Advanced" Tab of the primary panel:
IMPORTANT: In order to proceed to Step #5 please wait for the Secondary panel to be
Step # 5. Restore the System Wide Backup and select the "Restore this panel only" option.
(If a backup hadn't been performed the Panel-specific Data will need to be
re-programmed.)
The Synchronization will remove the Common Database from the
Secondary panels. Refer to the "Synchronization Detail Chart"
of the Secondary panels are registered with the Primary. Refer to the "Restore
Entire Loop Detail Chart"
• EVL Tab: Menu > Panel Configuration > Advanced > EVL Discovery.
• EVL Installations: Requires Manual Registration of the Secondary Panel.
• Navigate to the EVL Discovery and "Register" the Secondary Panels.
synchronized. Refer to the "Synchronization Detail Chart"
Note For the Ethernet Virtual Loop (EVL) a manual registration is required.
• Refer to the "Restore Entire Loop Detail Chart"
Document 800-26311_ A - February 2020
| 97