Adding A Micro-Grid To A Stored Value; Creating And Navigating Within A Micro-Grid - GE DMS Go Operator's Manual

Chapter 6. Working with Recorded Data
6.5

Adding a Micro-Grid to a Stored Value

If users wish to record additional thickness measurement data in a single file location, they can create a Micro-Grid. Micro-Grids are small
data subsets within a file. The entire subset is stored at one specific data location. Micro-Grids are created in the Measure mode. They can
only be stored in a file location that already contains a thickness measurement and are placed in the data file location selected at the time of
Micro-Grid creation.
6.5.1

Creating and Navigating Within a Micro-Grid

1. In the Measure mode, with a data file active and the desired data point (which must already contain a thickness measurement) selected,
center-press and briefly hold the joystick.The function key window will now change, so that Function 1 is

GRID) The Micro-Grid window opens on the display screen, next to a value representing the grid's size. Note that
2. Press Function 1 (
all Micro-Grids must be symmetrical; that is, they must have the same number of rows and columns. Micro-Grids can be created in
sizes ranging from 2 × 2 to 9 × 9.
3. Set the size of the Micro-Grid by using the joystick to scroll to the desired value.
4. When you have entered the size information, press F 2 (DONE). The DMS Go will return to Measure mode, and the Micro Grid will be
open for data entry. Enter data as you would in a DR file.
5. When you have completed entering data, press F3 (
122
Your Complete Source for
Testing Equipment. Since 1969!

GRID) to close the Micro-Grid.
www.BergEng.com
Berg Engineering & Sales Company, Inc.

GRID.
DMS Go Operator's Manual
1-847-577-3980
Info@BergEng.com