Display Programming; Changing Value For One Or Two-Variable Screens - GE PanaFlow HT User Manual

3.4 Display Programming

The XMT900 has three types of displays: one variable, two variables, and totalizer as shown below. From this display,
you can scroll to and change either the measurement type or value decimals with either the [] or []buttons.
Velocity
10.5

3.4.1 Changing Value for One or Two-Variable Screens

An outline of a typical one- or two-variable screen appears below.
Measurement Type
Error Code
To change the number of decimal places in the value:
Velocity
10.5
m/s
Velocity
10.5
m/s
appropriate value. (Available options include 0, 1, 2, 3, 4, and Sci (Scientific
Notation). Press [  o select the value, and then [  ] again to confirm the selection or
] t

[ ] t
o cancel the selection.
PanaFlow HT User's Manual
Velocity
m/s
Soundspeed
Velocity
Value
Figure 23: One-Variable Screen
From the display screen, press either the [] or [] buttons until the value is
highlighted
Once the value is highlighted, press
Use the [] and [] buttons to scroll to the
65535 m/s
234.0
m/s
10.5
m/s

[ ]
Chapter 3. Initial Setup and Programming
Total m^3
Fwd Batch
Rev Batch
E0
Value Units
Display/Decimal
to open the
Display/Decimal
0
1
2
3
4
0.00
0.00
option.
29