Manual Transmission
\
1 2 x 1 . 2 5 m m
64 N.m
{6.5 ksf.m,
47 tbf.ft)
30.
Transmission Removal (cont'd)
Pull the transmission away from the engine until
the transmission mainshaft clears the clutch
pressure plate, then lower the transmission on the
transmission jack.
Remove the transmission rear mount (A) and the
transmission rear mount bracket {B).
Remove the boot (A), the release fork {B). and the
r e l e a s e b e a r i n g ( C ) f r o m t h e t r a n s m i s s i o n ( D ) .
3 2 .
13-8
Transmission Installation
Special Tools Required
. Engine hanger adapter, 2.0 to 2.4 liter VS802C000015
. E n g i n e h a n g e r V S 8 0 2 C 0 0 0 0 1 8
. Engine support hanger, A & Reds AAR-T-12566"
. subframe adaDter EoS02c000011
* Available through the Honda Tool and Equipment
Program 888-424-6857
1. Check the two dowel pins are installed in the clutch
h o u s r n g .
Apply super high temp urea grease (P/N 08798-
9002) to the release fork (A) and the release bearing
(B). Installthe release fork and the release bearing.
0.4 1.0 g {0.01 0.04 ozl
3 . I n s t a l l t h e t r a n s m i s s i o n r e a r m o u n t b r a c k e t ( A ) a n d
t h e t r a n s m i s s i o n r e a r m o u n t ( B ) .
x 1 . 2 5 m m
N m {6.5 kgf.m,
P l a c e t h e t r a n s m i s s i o n o n t h e t r a n s m i s s i o n i a c k .
and raise it to the engine level.
't2
64
47
1 . 0 ' 1 . 6 g
{0.04 0.06 oz)