Transmission Installation - Honda Civic 2002-2003 Service Manual

Manual Transmission
Transmission Removal (cont'd)
30. Pull the transmission away from the engine until
the transmission mainshaft clears the clutch
pressure plate, then lower the transmission on the
transmission jack.
31. Remove the transmission rear mount (A) and the
transmission rear mount bracket (B).
32. Remove the boot (Al, the release fork (B), and the
release bearing (C) from the transmission (0).
13-8
Transmission Installation
Special Tools Required
• Engine hanger adapter, 2.0 to 2.4 liter VSB02C000015
• Engine hanger VSB02C000018
• Engine support hanger, A & Reds AAR-T-12566'
• Subframe adapter EQS02C000011
• Available through the Honda Tool and Equipment
Program 888-424-6857
1. Check the two dowel pins are installed in the clutch
housing.
2. Apply super high temp urea grease
(PIN
08798-
9002) to the release fork (A) and the release bearing
(B). Install the release fork and the release bearing.
1.0-1.6 g
(0.04-0.060z)
. /
~A
//~'i,~
0.4-1.0 g 10.01-0.04 oz)
3. Install the transmission rear mount bracket (A) and
the transmission rear mount (B).
12
x
1.25
mm
64 N·m (6.5 kgf·m,
47
Ibf':.!.ft~I,--
_ _ _ _
~~
-"'_,
12
x
1.25
mm
64N·m
(6.5 kgf·m,
471bS
4. Place the transmission on the transmission jack,
and raise
it
to the engine level.
•
•
•