Cisco ONS 15454 Manual page 71

Turning Up a Node
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
In node view, click the Provisioning > SNMP > SNMP V3 > Trap Destinations (V3) tabs.
Step 2 Click Create.
Step 3
In the Configure SNMPv3 Trap dialog box, enter the following information:
• Target Address—Target to which the traps should be sent. Use an IPv4 or an IPv6 address.
• UDP Port—UDP port number that the host uses. Default value is 162.
• User Name—Specify the name of the user on the host that connects to the agent.
• Security Level—Select one of the following options:
• Filter Profile—Select this check box and enter the filter profile name. Traps are sent only if you provide
• Proxy Traps Only—If selected, forwards only proxy traps from the ENE. Traps from this node are not
• Proxy Tags—Specify a list of tags. The tag list is needed on a GNE only if an ENE needs to send traps
Step 4
Click OK to save the information.
Step 5 Return to your originating procedure .
DLP-G500 Deleting SNMPv3 Trap Destination
Purpose
Tools/Equipment
Prerequisite Procedures
• noAuthNoPriv—Uses a user name match for authentication.
• AuthNoPriv—Provides authentication based on the HMAC-MD5 or HMAC-SHA algorithms.
• AuthPriv—Provides authentication based on the HMAC-MD5 or HMAC-SHA algorithms. Provides
DES 56-bit encryption based on the CBC-DES (DES-56) standard, in addition to authentication.
a filter profile name and create a notification filter. For more information, see
Notification Filters, on page
sent to the trap destination identified by this entry.
to the trap destination identified by this entry, and wants to use the GNE as the proxy.
"Login to CTC" in System Setup and Software
Installation Guide for Cisco NCS 4000 Series
As needed
Onsite
Provisioning or higher
72.
This procedure deletes an SNMPv3 trap destination.
None
DLP-G46 Log into CTC
DLP-G500 Deleting SNMPv3 Trap Destination
DLP-G501 Creating
Turning Up a Node
71