Cisco ONS 15454 Manual page 63

Turning Up a Node
NTP-G210 Provisioning Node for SNMPv3
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1 In node view, click the Provisioning > SNMP > SNMP V3 tabs.
Step 2
Complete the following tasks as required:
•
•
•
Stop. You have completed this procedure.
NTP-G211 Provisioning Node to Send SNMPv3 Traps
Purpose
Tools/Equipment
Prerequisite Procedures
DLP-G496 Creating an SNMPv3 User, on page 68
DLP-G498 Create Group Access , on page 69
Note A group named default_group is defined in the initial configuration. The default group has
read and notify access to the complete MIB tree.
DLP-G497 Create MIB Views , on page 69
A view named full_view is defined in the initial configuration. It includes the complete MIB
Note
tree supported on the node.
NTP-G210 Provisioning Node for SNMPv3
This procedure provisions the node to allow SNMPv3
access.
None
• DLP-G46 Log into CTC
• NTP-G22 Verifying Common Card Installation
Required if you want to implement SNMPv3 on your
network.
Onsite or remote
Provisioning or higher
This procedure provisions a node to send SNMP v3
traps.
None
• DLP-G46 Log into CTC
• NTP-G22 Verifying Common Card Installation
Turning Up a Node
63