Cisco ONS 15454 Manual page 65

Turning Up a Node
Procedure
Step 1
Go to network view.
Step 2 Double-click the ENE.
Step 3
Click Provisioning > SNMP > SNMP V3 > General and note the context engine ID. The is required in
Step
Step 4
Double-click the GNE.
Step 5 Complete the
Step 6
Complete the following tasks as needed on the ENE:
•
•
•
Step 7
Complete the
context engine ID from
Stop. You have completed this procedure.
NTP-G213 Automatically Provisioning a GNE to Manage an ENE
using SNMPv3
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
Go to network view.
Step 2 Double-click the GNE.
7.
DLP-G496 Creating an SNMPv3 User, on page 68
DLP-G496 Creating an SNMPv3 User, on page 68
DLP-G498 Create Group Access , on page 69
DLP-G497 Create MIB Views , on page 69
DLP-G502 Manually Configuring the SNMPv3 Proxy Forwarder Table, on page
Step 3, the local user details created in
NTP-G213 Automatically Provisioning a GNE to Manage an ENE using SNMPv3
to create an SNMPv3 user on the GNE.
Step
This procedure describes how to automatically
configure a GNE to allow an NMS to manage an ENE
using SNMPv3.
None
• DLP-G46 Log into CTC
• NTP-G22 Verifying Common Card Installation
Required if you want to implement SNMPv3 on your
network.
Onsite or remote
Provisioning or higher
5, and the remote user created in
Turning Up a Node
73. Use the
Step 6.
65