Cisco ONS 15454 Manual page 56

DLP-G375 Installing Fiber-Optic Cables on the Y-Cable Modules in the FlexLayer Shelf
Required/As Needed
Onsite/Remote
Security Level
Note To use Y-cable protection for GE_XP, 10GE_XP, GE_XPE, and 10GE_XPE cards, the cards must be
provisioned in 10GE MXP, 20GE MXP, or 10GE TXP mode. Y-cable protection cannot be used for GE_XP,
10GE_XP, GE_XPE, and 10GE_XPE cards that are provisioned in L2-over-DWDM mode.
Procedure
Step 1
As needed, complete the
Shelf, on page
Step 2 As needed, complete the
Module Tray, on page
Stop. You have completed this procedure.
DLP-G375InstallingFiber-OpticCablesontheY-CableModulesintheFlexLayer
Shelf
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Turning Up a Node
56
DLP-G375 Installing Fiber-Optic Cables on the Y-Cable Modules in the FlexLayer
56.
DLP-G376 Installing Fiber-Optic Cables on the Y-Cable Modules in the Y-Cable
58.
As needed
Onsite
None
This task installs fiber-optic cables from the TXP,
MXP, GE_XP, 10GE_XP, GE_XPE, 10GE_XPE,
AR_MXP, AR_XP, or AR_XPE cards to the Y-cable
modules installed in the FlexLayer shelves, and from
the Y-cable modules to the client devices.
Fiber-optic cables
Cisco Transport Planner Internal Connections Report
"DLP-G32 Install the Y-Cable Protection Modules in
the FlexLayer Shelf" in the
Hardware Installation Guide
NTP-G179 Installing the Transponder and Muxponder
Cards
As needed
Onsite
None
Turning Up a Node
Cisco ONS 15454