Cisco ONS 15454 Manual page 57

Turning Up a Node
Procedure
Step 1
Referring to the Cisco Transport Planner Internal Connections Report, install a fiber-optic cable between a
TXP, MXP, GE_XP, 10GE_XP, GE_XPE, 10GE_XPE, AR_MXP, AR_XP, or AR_XPE card and a Y-cable
module.
If you want to protect one client signal or protect two client signals using a single Y-cable module, connect
the fiber-optic cables according to the following tables.
Table 5: Cable Connections for Y-Cable Protection of One Client Signal
From
Client 1 TX port
Client 1 RX port
TXP/MXP/GE_XP/GE_XPE/10GE_XP/10GE_XPE
1 TX port
TXP/MXP/GE_XP/GE_XPE/10GE_XP/10GE_XPE
1 RX port
TXP/MXP/GE_XP/GE_XPE/10GE_XP/10GE_XPE
2TX port
TXP/MXP/GE_XP/GE_XPE/10GE_XP/10GE_XPE2RX
port
Table 6: Cable Connections for Y-Cable Protection of a Second Client Signal
From
Client 2 TX port
Client 2 RX port
TXP/MXP/GE_XP/GE_XPE/10GE_XP/10GE_XPE3
TX port
TXP/MXP/GE_XP/GE_XPE/10GE_XP/10GE_XPE
3 RX port
TXP/MXP/GE_XP/GE_XPE/10GE_XP/10GE_XPE
4 TX port
TXP/MXP/GE_XP/GE_XPE/10GE_XP/10GE_XPE
4 RX port
Step 2
As needed, route slack fiber-optic cable around the round cable retainers in the fiber-storage tray as you install
cables between the Y-cable module and the TXP, MXP, GE_XP, 10GE_XP, GE_XPE, or 10GE_XPE cards
(Figure 2: Fiber-Storage Tray, on page
DLP-G375 Installing Fiber-Optic Cables on the Y-Cable Modules in the FlexLayer Shelf
To (Y-Cable Port Number)
10
5
1
2
6
7
To (Y-Cable Port Number)
12
11
3
4
8
9
29).
Turning Up a Node
57