Cisco ONS 15454 Manual page 40

DLP-G356 Installing Fiber-Optic Cables from the 32WSS/32DMX and 32MUX-O/32DMX-O Cards to the Deep Patch Panel Tray
Step 4
Plug one end of a fiber-optic cable into the RX port of the DWDM adapter on the TXP, MXP, GE_XP,
10GE_XP, GE_XPE, 10GE_XPE, ADM-10G, or OTU2_XP card.
Step 5 On the DWDM (front) side of the patch panel, plug the other end of the cable into the connector on the top
row that corresponds to the wavelength to which the TXP, MXP, GE_XP, 10GE_XP, GE_XPE, 10GE_XPE,
ADM-10G, or OTU2_XP card is tuned.
Step 6
Repeat Steps
or OTU2_XP cards that you want to connect to this patch panel.
Step 7
Return to your originating procedure (NTP).
DLP-G356 Installing Fiber-Optic Cables from the 32WSS/32DMX and
32MUX-O/32DMX-O Cards to the Deep Patch Panel Tray
Purpose
Turning Up a Node
40
1 through 5 for all of the TXP, MXP, GE_XP, 10GE_XP, GE_XPE, 10GE_XPE, ADM-10G,
This task describes how to route fiber-optic cables
from 32MUX-O, 32WSS, 32DMX-O, and 32DMX
cards in a terminal, hub, or ROADM node to the deep
patch panel tray.
Turning Up a Node