Cisco ONS 15454 Manual page 67

Turning Up a Node
Step 8
On the ENE, complete the
address should be the IP address of the GNE. The UDP port number is 161. Use the user name configured in
Step
Step 9
From the network view, click the Provisioning > SNMPv3 tabs.
Step 10 Complete the
The source of the trap must be the IP address of the ENE. For the field, provide the of the ENE. Also, you
need to specify the target tag defined in
Stop. You have completed this procedure.
NTP-G215 Automatically Provisioning a GNE/ENE to Send
SNMPv3 Traps Using SNMPv3
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
Go to Network View.
Step 2 Double-click the GNE.
Step 3
Complete the task
Step 4 On the GNE, complete the following tasks:
•
•
NTP-G215 Automatically Provisioning a GNE/ENE to Send SNMPv3 Traps Using SNMPv3
DLP-G499 Configure SNMPv3 Trap Destination , on page
6.
DLP-G504 Manually Configuring the SNMPv3 Proxy Trap Forwarder Table, on page
DLP-G496 Creating an SNMPv3 User, on page 68
DLP-G499 Configure SNMPv3 Trap Destination , on page
or IPv6 address of the NMS. For the UDP Port number, use the port number on which the NMS is listening
for traps. Also, specify a target tag name.
DLP-G505 Automatically Configuring the SNMPv3 Proxy Trap Forwarder Table, on page
target tag configured in Step
are created automatically:
• A user named ons_trap_user on the ENE
Step 4, and the incoming user details configured in
This procedure describes how to automatically
configure the GNE/ENE to allow an ENE to send
SNMPv3 traps to the NMS.
None
• DLP-G46 Log into CTC
• NTP-G22 Verifying Common Card Installation
Required if you want to implement SNMPv3 on your
network.
Onsite or remote
Provisioning or higher
3. Use the IP address of the ENE as the source of trap. The following details
70. The target IP
Step
to create an SNMPv3 user on the GNE.
70. The target IP address must be the IPv4
Turning Up a Node
75.
6.
76. Use the
67