Cisco ONS 15454 Manual page 66

NTP-G214 Manually Provisioning a GNE/ENE to Send SNMPv3 Traps using SNMPv3
Step 3
Complete the
Step 4 Complete the
the GNE user that you defined in
Note
Stop. You have completed this procedure.
NTP-G214 Manually Provisioning a GNE/ENE to Send SNMPv3
Traps using SNMPv3
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Procedure
Step 1
Go to network view.
Step 2 Double-click the GNE.
Step 3
Complete the
Step 4 On the GNE, complete the
address must be the IPv4 or IPv6 address of the NMS. For the UDP Port number, use the port number on
which the NMS is listening for traps. Use the user name configured in
Step 5 Double-click the ENE.
Step 6
Complete the
Step 7 Complete the following tasks as required:
•
•
•
Turning Up a Node
66
DLP-G496 Creating an SNMPv3 User, on page 68
DLP-G503 Automatically Configuring the SNMPv3 Proxy Forwarder Table, on page
When you use the automatic procedure, CTC automatically creates an ons_proxy user on the ENE,
provides ENE user details for the proxy configuration, and provides the of the ENE.
DLP-G496 Creating an SNMPv3 User, on page 68
DLP-G499 Configure SNMPv3 Trap Destination , on page
DLP-G496 Creating an SNMPv3 User, on page 68
DLP-G498 Create Group Access , on page 69
DLP-G497 Create MIB Views , on page 69
DLP-G501 Creating Notification Filters, on page 72
Step 3 when you configure the Proxy Forwarder table.
This procedure describes how to manually configure
the GNE/ENE to allow an ENE to send SNMPv3 traps
to the NMS.
None
• DLP-G46 Log into CTC
• NTP-G22 Verifying Common Card Installation
Required if you want to implement SNMPv3 on your
network.
Onsite or remote
Provisioning or higher
to create a group on the ENE
to create a MIB view on the ENE
Turning Up a Node
to create an SNMPv3 user on the GNE.
to create an SNMPv3 user on the GNE.
70. The target IP
Step 3. Also, specify a target tag name.
to create an SNMPv3 user on the ENE.
74. Use