Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 68

Installing the Front Door and Air Intake Frame
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
1
Align the left door stopper to the cable
management frame.
Place two bushings on the vertical post located half way up the right cable management frame (see
Step 2
Figure
Figure 2-18
1 Split open the bushings and fit them around
the cable management frame post.
Assemble the two pieces of the right door stop over the bushings and post. Fasten the two pieces together
Step 3
with two M4 flathead screws (see
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
2-28
2-18). You must open each bushing to fit it around the post.
Placing Two Bushings on a Cable Management Frame Hinge Post
2
Fasten the left door stopper to the frame with
two M3 x 10 mm screws.
Figure 2-19).
Chapter 2 Installing a Cisco Nexus 7009 Chassis
OL-23069-06