Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 272

Replacing the Front Doors and Frame Assembly on the Cisco Nexus 7010 Chassis
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 9-23
1
Completely loosen four captive screws.
On the right side of the EMI panel (as seen from the front), align the right frame piece (the one with the
Step 5
notch in one of the two extensions) so that its two screw holes align to two screw holes on one side of
the EMI panel and secure the side frame to the panel with two 6-32 x 1/2 inch flat head screws. Tighten
the screws to 8 in-lb (0.9 N·m). See
On the left side of the EMI panel, align the left frame piece (no notch on its extensions) so that its two
Step 6
screw holes align to two screw holes on one side of the EMI panel and secure the side frame to the panel
with two 6-32 x 1/2 inch flat head screws. Tighten the screws to 8 in-lb (0.9 N·m). See
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
9-50
Removing the EMI Panel
Figure
2
Remove the EMI panel from the chassis.
9-24.
Chapter 9 Replacement Procedures
Figure 9-24.
OL-23069-06