Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 265

Chapter 9 Replacement Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
If you are installing a new chassis, you do not need to perform this task because the chassis is not shipped
Note
with these assemblies attached to it.
To remove the front doors and frame assemblies, follow these steps:
Remove the two lower side frames from the EMI air filter frame by first removing the EMI panel from
Step 1
the chassis, and then unscrewing the side frame pieces. When done, replace the EMI frame on the
chassis. The following steps explain each of these tasks:
On the EMI panel, which covers the air intake area on the lower front side of the chassis, loosen and
a.
completely unscrew each of the four captive screws that hold the panel to the chassis.
Pull the EMI panel away from the chassis, along with the attached side frame members and optional
b.
air filter (if attached) (see
Figure 9-16
OL-23069-06
Replacing the Front Doors and Frame Assembly on the Cisco Nexus 7010 Chassis
Figure 9-16).
Removing the EMI Panel From the Chassis
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
9-43