Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 377

Appendix E Repacking the Cisco Nexus 7000 Series Switch for Shipment
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure E-10
1 Remove four M4x8 pan-headed screws
from the chassis.
h. Remove the bracket from the chassis and place it in the opened box for that bracket.
Fold the box flaps over the bracket and tape them together and to the box.
i.
Loosen and remove the two M3x10 screws that hold the right door stopper to the right cable
j.
management frame. Place the two screws and the door stopper in the small parts bag for the door.
Loosen and remove the two M3x10 screws that hold the left door stopper to the left cable
k.
management frame. Place the two screws and the door stopper in the small parts bag for the door.
Fold the short box flaps over the top, fold the long box flaps over the short flaps, and then tape the
l.
long flaps together and to the box with packing tape.
Loosen the two captive screws on the air intake frame (there is one captive screw on each side) so
m.
that they are no longer in contact with the chassis (see Callout 1 in
OL-23069-06
Removing the Bottom Hinge Bracket
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Repacking the System Components
2 Remove four M4x8 screws from the cable
management assemblies (two screws on each side).
Figure E-11).
E-21