Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 258

Replacing a Cisco Nexus 7010 or 7018 Fabric Module During Operations
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 9-15
1
Open the box.
2
Place the foam padding on the bottom.
3 Place the foam padding with the middle cut
out on top of the foam padding in the box.
4 Put the fabric module in an ESD bag (not
shown) and then place the bagged module in
the hole of the padding.
On the replacement module, rotate the two ejector levers fully away from the face of the module.
Step 10
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
9-36
Packing a Cisco Nexus 7018 Fabric Module (N7K-C7018-FAB-1)
Chapter 9
5
Place the two foam pads on top of the module.
6
Fold the narrow flaps over the top of the box.
7 Fold the wide flaps over the top of the box.
8 Tape the wide flaps together and to the box.
Replacement Procedures
OL-23069-06