Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 296

Replacing the Front Door and Air Intake Assemblies on the Cisco Nexus 7018 Chassis
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 9-44
1
Four M4x8 pan-head screws that fasten the
bottom hinge bracket to the chassis.
Step 7 Tighten the four M4x8 screws that fasten the bottom hinge bracket to the chassis to 11 to 15 in-lb (1.2
to 1.7 N·m).
Step 8 Tighten the four M4x8 screws that fasten the bottom hinge bracket to the cable management frame to 11
to 15 in-lb (1.2 to 1.7 N·m).
Step 9 Fasten the four ball-point studs to the bottom portion of the chassis, one stud by each corner of the air
intake area as shown in
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
9-74
Attaching the Hinge Bracket to the Cable Management Frame and Chassis
Figure 9-45.
Chapter 9
2
Four M4x8 pan-head screws that fasten the
bottom hinge bracket to the left and right sides
of the cable management frame.
Replacement Procedures
OL-23069-06