Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 251

Chapter 9 Replacement Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 9-11
1 Put the module in an ESD bag.
2 Place the bagged module on the foam pad.
3
Attach a side pad to each of the long sides of
the module.
4
Fold the side flaps up along the side pads.
5
Fold the long flaps up along the ends of the
module and then over the top of the module.
Insert the two tabs on each flap into the side
flaps.
6 Insert the folded box into the slightly larger
box.
OL-23069-06
Repacking an 8- or 48-Port I/O Module (N7K-M108X2-12L, N7K-M148GT-11,
N7K-M148GT-11L, N7K-M148GS-11, or N7K-M148GS-11L)
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
7 Tape the flap to the box.
8 Insert the two box sides into foam blocks.
9
Place the box and its foam blocks into the
larger box.
10 Fold the narrow flaps over the smaller box and
foam blocks.
11 Fold the wide flaps over the box.
12 Tape the wide flaps together and to the box.
Replacing an I/O Module
9-29