Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 298

Replacing the Front Door and Air Intake Assemblies on the Cisco Nexus 7018 Chassis
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 9-46 Positioning the Air Intake Frame on the Chassis
1
Step 11 Fasten the captive screws on the air intake frame to the chassis and tighten to 11 to 15 in-lb (95 to
130 N·m).
Step 12 On the chassis door, pull the door handle open on one of the two sides of the door until the handle clicks
(the handle clicks when you pull it out about 30 degrees).
Move the side of the door with the opened handle onto the two hinge pins as shown in
Step 13
sure that the hinge pins on the top cover and bottom hinge bracket fit through the slots on the top and
bottom of that side of the door. Position the door so the hinge pins are located at the ends of the slots.
The double-hinged door can be installed and opened on either side. The figures in this procedure show
Note
how to install the door on the left side first, but you can use the instructions to install it on either side first.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
9-76
Ball-point studs
Chapter 9
2
Air-intake frame with holes to be aligned with
the ball-point studs
Replacement Procedures
Figure 9-47. Make
OL-23069-06