Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 86

Installing the Chassis
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 3-3
1 Push the lower half of the front side of the chassis 3
2 Chassis mounting brackets
Make sure that the screw holes in the chassis mounting brackets align with the screw holes in the vertical
Step 4
mounting rails.
If you need to reposition the chassis to align the screw holes, you can use the handles on the sides of the
chassis.
To adjust the placement of the chassis so that the screw holes in the chassis mounting brackets align with
Tip
the screw holes in the vertical mounting rails, use the chassis handles shown in
Use a Phillips screwdriver to screw in four M6 x 19-mm or 12-24 x 3/4-inch screws in each of the two
Step 5
chassis mounting brackets (use a total of eight screws for two mounting brackets) as shown in
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
3-10
Moving a Cisco Nexus 7010 Chassis onto a Rack
Chapter 3 Installing a Cisco Nexus 7010 Chassis
Rack vertical mounting rails
Figure 3-4.
Figure 3-4.
OL-23069-06