Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 237

Chapter 9 Replacement Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 9-5
1 Unscrew two captive screws.
2
Simultaneously press both ejector buttons.
Press the ejector release buttons on the ends of the module (see View B of
Step 4
ejector levers and to disconnect the module.
If the chassis has two supervisor modules and you disconnect the active supervisor module, that
supervisor goes into standby mode and the other supervisor automatically becomes the active supervisor.
Disconnect the cables attached to the front of the module to be removed. Make sure that each cable is
Step 5
labelled for its port on the module.
Simultaneously rotate the two ejector levers outward to unseat the module from the midplane connector
Step 6
(see View C of
With a hand on each ejector, pull the module part way out of its slot in the chassis.
Step 7
Grasp the front edge of the module with your left hand and place your right hand under the lower side
Step 8
of the module to support its weight. Pull the module out of its slot.
OL-23069-06
Unseating a Supervisor Module
Figure 9-5).
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Replacing a Supervisor Module
3 Simultaneously swing open both ejector
levers to unseat the module.
Figure 9-5) to push out the
9-15