Table of Contents
Advertisement
1.3 Hardware Setup
1.4 Mechanical Layout
22 SBC622 Hardware Reference Manual
The SBC622 is factory populated with user‐specified options as part of the SBC622
ordering information. Contact Sales for ordering information at
1‐800‐322‐3616. For option upgrades or for any type of repairs, contact customer
care to receive a Return Material Authorization (RMA).
GE Customer Care is available at: 1‐800‐433‐2682, 1‐780‐401‐7700.
Or, visit our website at:
www.ge-ip.com
The SBC622 is tested for system operation and shipped with factory‐installed
jumpers, headers and connectors. The physical locations of the jumpers, headers
and connectors for the SBC with the PMC option are illustrated in Figure 1‐1 Top
Assembly Jumpers, Headers, Connectors Locations on page 23. The definitions of
the jumpers, headers and connectors are included in Table 1‐1 Jumpers, Headers,
Connectors on page 24.
All jumpers marked User Configured in the following tables may be changed or modified by the
user. All jumpers marked Factory Configured should not be modified by the user.
Care must be taken when making jumper modifications to ensure against improper settings or
connections. Improper settings may result in damage to the unit .
Modifying any jumper marked Factory Configured will void the Warranty and may damage the
unit .
The SBC622 is constructed as a single 6U VPX board that meets the mechanical
requirements defined in the VITA 46.0 specification.
For installation instructions, see Section 1.7 Installation of SBC622 into Chassis
on page 29 and Section 1.8 Installing or Removing a PMC Card on page 32.
The SBC622 Top Assembly is illustrated in the following figure:
Advertisement
Table of Contents
