Serial Port Connector Rj45 (J10); Usb Connectors And Pinout (J1, J3); Figure A-3 Serial Connector (J10); Figure A-4 Usb Port (J1, J3) - GE OpenVPX VPXcel6 SBC622 Hardware Reference Manual

A.2 Serial Port Connector RJ45 (J10)
A.3 USB Connectors and Pinout (J1, J3)
The COM 3 Serial Port Connector located on the Front Panel, is a standard RJ45
connector as shown in the figure and table below:

Figure A-3 Serial Connector (J10)

Table A-15 Serial Connector Pinout (J10)

Pin RS232 (Default) Mode
1 DCD#
2 RTS#
3 GND
4 TX
5 RX
6 GND
7 CTS#
8 DTR#
NOTE: See the appropriate table of jumper and switch settings for configuring. A cable is
available (PN:42G7602-0003) to convert from the RJ45 connector to a standard DB9 Male
connector.
The two USB ports on the Front Panel are industry standard 4‐position shielded
connectors. The figure below depicts a representation of the connectors, and the
table that follows shows the pinout (same for each).

Figure A-4 USB Port (J1, J3)

Table A-16 USB Connectors (J1, J3)

Pin Signal
1 USB_VCC
2 USB-
3 USB+
4 USBG
RS422 Mode
RXD+
RTS-
TXD+
TXD-
RXD-
CTS+
CTS-
RTS+
Function
USB Power
USB Data -
USB Data +
USB Ground
Appendix A: Connectors and Pinouts 76