Table of Contents
Advertisement
86
When using two size D batteries, the value 13.0 Ah should
be entered for "Bat.C". When using four batteries, the value
26.0 Ah must be entered.
–
After you have changed all digits, press the ENTER button to confirm
the inputs. The input value can be deleted by pressing the ESC
button.
–
For closing the administrator lock move the cursor to the "Admin"
register and to the "St.AL" value (status administrator lock) via the
following path:
Admin.
Press the ENTER button. "open" will start to flash.
–
–
Move the cursor using the arrow keys or to change the value to
"locked".
–
After you have changed the value, press the ENTER button to
confirm the inputs. The input value can be deleted by pressing the
ESC button.
7.2.3 Display remaining battery power
The remaining battery power is calculated separately from
the consumed power (which is measured) and from the
anticipated future consumption (giving the theoretical
remaining battery power). Therefore, for applications which
are very power-consuming, the remaining battery power
may drop quicker than is shown on the battery power
display.
The remaining battery power will automatically be
recalculated after entering a new battery capacity "Bat.C"
(see above). The value cannot be edited.
–
Move the cursor to the "Serv." register and to the "Bat.R" value
(remaining battery power) via the following path:
Serv.
After entering the new battery capacity, a value of at least
60 months will be displayed in standard measurement
conditions (see chapter 3.2.1) for "Bat.R".
Device settings
Batteries
Bat.R
Access
St.AL
Maintenance
Advertisement
Table of Contents
