Table of Contents
Advertisement
72
6.4
Data register content
6.4.1 Access rights
The "Access" column in the tables in the following chapter describes which
lock must be opened in order to change a parameter. All parameter
changes are saved in a log.
Access Meaning
C
Calibration officer
6
CDL
Certification data log
A
Administrator
Cu
Customer
-
No access
6.4.2 "Main" register (main display)
An overview of the most important measurements is presented in the
"Main" register. The contents may vary depending on the parameterization
( chapter 6.4.6.5).
It is not possible to move the cursor to a value in this register
the "ENTER" button, the displayed values are updated.
Display
Meaning
Vb
Volume at base conditions
Vm
Volume at measurement
conditions
P
Pressure
K
Compressibility ratio factor
T
Temperature
C
Conversion factor
Vb – Volume at base conditions
6.4.2.1
The volume measured by the connected gas meter will be converted into a
quantity at base conditions and totalled in this counter.
If there is a fault (see chapter 8 "Faults"), the Vb counter will be stopped
and the volume will be totalled in a special disturbance quantity counter.
6
If a configuration log is in a device.
The exception is if the „
7
" tab was set to „
Main
7
. By pressing
Unit
Access Address
3
m
C
3
m
C
bar
-
-
-
°C
-
-
-
" (see chapter 6.4.6.5).
List
Operation
2:300
4:300
7:310_1
8:310
6:310_1
5:310
Advertisement
Table of Contents
