Table of Contents
Advertisement
54
If, when the administrator lock is open, the assumption of
„VbA" for „Vb"is rejected with the message –13--, then this
process has already been carried out once.
Other changes are possible if the calibration lock is open or, if
the administrator lock is open, after deleting the change
information for comparison of „Vb" (see chapter 5.3.1.9).
5.3.1.9
Deleting change information for comparison of Vb with the
gas meter
In order to allow the volume at base conditions to be reset if the
administrator lock is open, the change information for comparison of „Vb"
must be deleted:
–
Open the calibration lock
–
Move the cursor to the „Serv." tab and go to the value „Clear"
(deleting change information) via the following path:
Serv.
Clear
Press the ENTER key. „0" flashes.
–
Change the value using the arrow keys or to „1"
–
–
Once you have changed the value, press the ENTER key in order to
confirm your entry. The entry can be cancelled by pressing the ESC
key. „TimeX" (time stamp of comparison), „Vb_o" (Vb old value),
„Vb_n" (Vb new value) are set to default values.
Assembly, Connection and Putting into Operation
Volume
Standard volume
Synchronization Vb
Advertisement
Table of Contents
