Disassembly - Honda Civic 1998 Service Manual

Disassembly
1 .
Caretully clamp the driveshaft in a vise with soft
jaws, then remove the set ring from the inboard
joint.
To remove the boot band, pry up the locking tabs
with a screwdriver and raise the end of the band.
Take care not to damage the boot.
SET RING
Replace.
- lf the boot band is the welded type, cut it off as
snown.
BOOT BAND
Replace.
-
lf the boot band is the crimping type, pry up the
end of the band with a screwdriver.
BOOT BAND
Replace.
-
It the boot band is double loop type, raise the
band bend as shown.
DOUB1I I.OOP BAND
R6place.
Mark each roller and inboard ioint to identify the
locations of rollers and grooves in the inboard joint.
Then remove the inboard joint on the shop towel.
Be careful not to drop the rollers when separatang
them from the inboard joint.
INBOARD JOINT
Check splines lor wear or damage
Check inside bore for wear'
Inspect {or cracks.
Mark3
{cont'd)
1 6 - 5