Honda Civic 1998 Service Manual page 986

5. Installation is the reverse of the removal procedure.
NOTE:
. Check that the retractor locking mechanism func-
tions as described on page 20-91.
Make sure you assemble the washers and collars
on the uoDer and lower anchor bolts as shown.
Before installing the anchor bolts, make sure there
are no twists or kinks in the front seat beit.
Upper anchor bolt construclion:
SPRING
WASHER
Lower anchor bolt construction:
SPRING
WASHER
BEARING
COLLARS
WASHERS LowER
LOCK WASHER
Retractor bolt construction:
BEARING
ANCHOR
LOWER ANCHOR
BOLT
RETBACTOR
TOOTHEO
LOCK WASHER
b
WASHERS
RETRACTOB
20-87
Seat beh buckle removal:
1 .
2 .
R e m o v e t h e f r o n t s e a t t h r o u g h t h e d o o r o p e n i n g
(see page 20 74).
Remove the center cover (see pages 20-75, 76).
Remove the center anchor bolt, then remove the seat
belt buckle.
SEAT BELT
BUCKLE
CLIP
32 N'm {3.3 kgf m, 2't lbfft)
4.
Driver's: Detach the seat belt switch connector and
harness clip from the seat cushion (see page 20-77).
Remove the seat cushion mounting bolts from the
inner seat track {see page 20-751, and move the inner
seat track, then pull the seat belt switch harness out.
NOTE: Take care not to damage the hinge bracket.
Center anchor bolt construction:
CENTER ANCHOR
BOLT
SPRING
WASHER
WASHER
5 . Installation is the reverse of the removal procedure.
NOTE: Make sure you assemble the washers and
bearing on the center anchor bolt as shown.
ANCHOR BOLT