Honda Civic 1998 Service Manual page 560

3.
lnstall the reverse selector hub on the countershaft
sub-assembly, and then press the reverse selector
hub using the special tool and a press as shown.
DRIVER 40 mm l.D.
07746 -OO30tOO
lnspection
a Clearance Measurement
NOTE: Lubricate all parts with ATF during assembly.
'L
Remove the countershaft bearing trom the trans-
mission housing (see page 14 142).
2.
Install the parts below on the countershaft using the
specialtool and a press as described on this page.
NOTE: Do not assemble the O-rings during inspec
t r o n .
REVERSE SELECTOR
H U B
4TH GEAR
NEEDLE BEARING
DISTANCE COLLAR, 28 mm
Selective part.
2ND GEAR
THRUST NEEDLE BEARING
3RD GEAR
NEEDLE BEARING
3RD GEAR COLLAR
THRUST NEEDLE BEARING
SPLINED WASHER
3RD CLUTCH ASSEMBLY
{cont'd)
14-121