Honda Civic 1998 Service Manual page 735

Driveshafts
Reassembly (cont'dl
1 .
Wrap the splines with vinyl tape to prevent damage
to the boots and dvnamic damoer.
APE
OUTBOARO BOOT
2 .
V;
Pack the outboard joint with the joint grease included
in the new driveshaft set,
Grease quantity:
Japan Produc€d:
7o - 80 g (2.5 - 2.a ozl
Except Japan Produced: 115 - 135 9 (i1.0 - 4.8 ozl
DYNAMIC DAMPER
I n s t a l l t h e o u t b o a r d
i n b o a r d b o o t t o t h e
vinyl tape. Take care
dynamic damper.
INAOARD BOOT
b o o t , d y n a m i c d a m p e r a n d
d r i v e s h a f t . t h e n r e m o v e t h e
not to damage the boots and
1 6 - 8
4 . I n s t a l l t h e s t o p r i n g i n t o t h e d r i v e s h a f t g r o o v e
{except Japan produced), Always rotate the stop
ring in its groove to be sure it is fully seated.
\zr|<-C|RCL|P
Install the spider on the driveshaft by aligning the
marks on the spider and end of the driveshaft.
Fit the circlip into the driveshaft groove. Always
rotate the circlip in its groove to be sure it is fully
seated.
Fit the rollers to the spider with their high shoulders
7 .
facing outward, and note these items:
. Reinstall the rollers in their original
the spider by aligning the marks.
. H o l d t h e d r i v e s h a f t p o i n t e d u D t o
rollers from talling off.
positions on
prevent the