Honda Civic 1998 Service Manual page 708

2 .
?
1 .
7 .
Install the ATF feed pipe in the transmission hous-
ing, and install the three ATF feed pipes with new
O - r i n g s i n t h e t r a n s m i s s i o n h o u s i n g .
Install the two dowel pins and new transmission hous-
ing gasket on the transmission housing.
Push the control shaft assembly toward the outside
of the transmission housing, then install the inter-
mediate housing assembly (four bolts).
lnstall the manual valve body separator plate and
the two dowel pins on the intermediate housing.
then install the manual valve body with the detent
spring (five bolts).
Put the control shaft assembly back, then install the
roller in the intermediate housing.
Install the reverse brake piston in the intermediate
housing.
lnstall the spring retainer/retu.n spring assembly on
the reverse brake Paston.
NOTE: Installthe return springs on the spring guides
oJ the reverse brake piston securelY
Install the special tool to compress the return sprlng
as shown.
REVERSE BRAKE
SPRING COMPRESSOE
o?TAE - P4V0110
CAUTION: lf the spring letainer tab is on the reverse
brake piston, the spring retainer may be damaged.
Be sure the spring retainer tab is not on the piston.
SPECIAL TOOL
REVERSE BRAKE
1 0 .
Compress the return springs. then install the snap
ring in the intermediate housing above the spring
retarner.
Verify that the snap ring end gap is correct
M i n i m u m 1 5 m m ( 0 . 5 9 i n )
,a7 "-,,,,.
/,.'
\.,
i r
'
i r
' ,
/ / /
,'t
.
:''
SNAP RING
S o a k t h e r e v e r s e b r a k e d i s c s t h o r o u g h l y i n C V T
F l u i d f o r m i n i m u m 3 0 m i n u t e s
Install the disc spring on the reverse brake piston.
S l a r t i n g w i t h a r e v e r s e b r a k e p l a t e , a l t e r n a t e l y
install the reverse brake plates and discs lnstall the
reverse brake end piate, and the snap ring
Measure the clearance between the reverse brake
end plate and the top disc with a dial indicator. Zero
t h e d i a l i n d i c a t o r w i t h a r e v e r s e b r a k e e n d p l a t e
lowered, and lift it up to the snap ring. The distance
that the reverse brake and plate moves is the clear-
ance between the reverse end plate, and the top
disc.
NOTE: Take measurements in at least three places,
and use the average as the actual clearance
STANDARD: 0.45 - 0.75 mm (0.018 - 0.030 in)
(cont'di
1 1 .
t 5 .
1 4 .
14-271