Honda Civic 1998 Service Manual page 689

1 . R e m o v e t h e r i g h t s i d e c o v e r ( t h r e e 6 m m b o l t s ,
eleven 8 mm bolts).
2. Remove the manual valve body lines A and B.
Remove the snap ring securing the ring gear, then
remove the thrust shim and the rang gear.
R e m o v e t h e s n a p r i n g s e c u r i n g t h e r e v e r s e b r a k e
discs and plates, then remove the reverse brake end
plate, brake discs, brake plates, and disc spring.
Remove the carrier with the thrust washers and the
thrust needle bearing, from the forward clutch.
Remove the sun gear and the input shaft as a sub
assembly by pulling ir.
The sun gear is press fitted tightly into input shaft.
Remove the snap ring securing the forward clutch,
and remove the snap ring securing the forward clutch
end plate, then remove the forward clutch end plate.
R e i n s t a l l t h e c a r r i e r o n t h e f o r w a r d c l u t c h , t h e n
secure the carrier with the snap ring on the forward
ciutch end plate.
3 .
6 .
7 .
8 .
9 . R e m o v e t h e f o r w a r d c l u t c h a n d c a r r i e r a s s e m b l y
together.
1 0 . I n s t a l l t h e s p e c i a l t o o l t o r e m o v e t h e s n a p r i n g
securing the reverse brake return spring retainer as
snown.
REVERSE BRAXE
SPRING COMPRESSOR
07TAE - P4V01r0
11. Compress the return springs. then remove the snap
r i n g .
C A U T I O N : l f t h e s p r i n g l e t a i n e r t a b i s o n t h e
leverse brake piston, the spring retainer may be
damaged. Be sure the spring retainer tab is not on
the piston.
SPRING RETAIiIER
TAA
R e m o v e t h e s p e c i a l t o o l , t h e n r e m o v e t h e s p r i n g
retainer/return spring assembly.
Remove the sealing bolt securing the reverse brake
pressure inspection hole.
Apply air pressure to the inspection hole to remove
the reverse brake piston.
12.
1 4 .
SPRNG RETAINER/
RETURN SPRING
ASSEMBLY
REVERSE BRAKE
PISTON
o-Rt Gs
Replace.
REVERSE BRAXE
PRESSUR€ INSPECNON
HOIT
SEALING
WASHER
Replace.
8 x 1 .25 mm
18 N.m {1.E kgl.m, 13 lbf.ftl
15. Remove the snap ring retainer from the drive pulley
shaft.
16. Remove the manual valve body (five bolts).
'17 Remove the roller, and Dush the control shaft assem-
bly toward the outside of the transmission housing,
then remove the intermediate housing (four bolts).
SPECIAL TOOL
14-251