Usermanagement Commands - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction
xCommand UserInterface ScreenShot Request
For internal use only.
Requires user role: ADMIN
Parameters:
Type(r): <Touchpanel/OSD>
ScreenShotId(r): <S: 0-50>
Example:
xCommand UserInterface ScreenShot Request ScreenShotId: 3 Type: OSD
xCommand UserInterface ScreenShot Store
For internal use only.
Requires user role: USER
Parameters:
Type(r): <Touchpanel/OSD>
Name: <S: 0, 35>
ScreenShotId(r): <S: 0-50>
Example:
xCommand UserInterface ScreenShot Store Type:OSD Name:5 ScreenShotId:5
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration

UserManagement commands

xCommand UserManagement RemoteSupportUser Create
xCommand UserManagement RemoteSupportUser Delete
xCommand UserManagement RemoteSupportUser DisablePermanently
131
xCommand xCommand
Create a remote support user passphrase that Technical Assistance Center (TAC) can use to access
the system for troubleshooting. You can set duration for the validity of the passphrase. It expires in 7
days by default.
Requires user role: ADMIN
Parameters:
ExpiryDays: <1..31>
Example:
xCommand UserManagement RemoteSupportUser Create
*r UserCreate (status=OK):
Username: remotesupport
Expiry: 2014-03-04 13:24:15 UTC
Passphrase: 1234567890
Delete the remote support user created with the command xCommand UserManagement
RemoteSupportUser Create.
Requires user role: ADMIN
Example:
xCommand UserManagement RemoteSupportUser Delete
Disable the creation of new remote support users. To enable the remote support user again you
must factory reset your system.
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
Example:
xCommand UserManagement RemoteSupportUser DisablePermanently Confirm: Yes
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.