Xcommand Userinterface Screenshot Request; Xcommand Userinterface Screenshot Store; Usermanagement Commands; Xcommand Usermanagement Remotesupportuser Create - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec
Contents Introduction

xCommand UserInterface ScreenShot Request

For internal use only.
Requires user role: ADMIN
Parameters:
Type(r): <Touchpanel/OSD>
ScreenShotId(r): <S: 0-50>
Example:
xCommand UserInterface ScreenShot Request ScreenShotId: 3 Type: OSD

xCommand UserInterface ScreenShot Store

For internal use only.
Requires user role: USER
Parameters:
Type(r): <Touchpanel/OSD>
Name: <S: 0, 35>
ScreenShotId(r): <S: 0-50>
Example:
xCommand UserInterface ScreenShot Store Type:OSD Name:5 ScreenShotId:5
SX20 Codec API Reference Guide TC7.3, OCTOBER 2015.
D14949.13
About the API xConfiguration

UserManagement commands

xCommand UserManagement RemoteSupportUser Create

xCommand UserManagement RemoteSupportUser Delete

xCommand UserManagement RemoteSupportUser DisablePermanently

123
xCommand xCommand
Create a remote support user passphrase that Technical Assistance Center (TAC) can use to access
the system for troubleshooting. You can set duration for the validity of the passphrase. It expires in 7
days by default.
Requires user role: ADMIN
Parameters:
ExpiryDays: <1..31>
Example:
xCommand UserManagement RemoteSupportUser Create
*r UserCreate (status=OK):
Username: remotesupport
Expiry: 2014-03-04 13:24:15 UTC
Passphrase: 1234567890
Delete the remote support user created with the command xCommand UserManagement
RemoteSupportUser Create.
Requires user role: ADMIN
Example:
xCommand UserManagement RemoteSupportUser Delete
Disable the creation of new remote support users. To enable the remote support user again you
must factory reset your system.
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
Example:
xCommand UserManagement RemoteSupportUser DisablePermanently Confirm: Yes
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.