Cisco TelePresence SX80 Reference Manual page 34

Cisco TelePresence SX80
Contents Introduction
xConfiguration Audio Input Microphone [1..8] Type
The microphone connectors are intended for electret type microphones. The microphone connector
can be set to line or microphone mode.
Requires user role: ADMIN
Value space: <Microphone/Line>
Microphone: Select Microphone when you have 48 V Phantom voltage and the pre-amplification
is On.
Line: Select Line when you have a standard balanced line input. The phantom voltage and
pre-amplification is Off.
Example: xConfiguration Audio Input Microphone 1 Type: Line
xConfiguration Audio Output HDMI [1..2] Level
Define the output level of the HDMI output connector, in steps of 1 dB.
Requires user role: ADMIN
Value space: <-24..0>
Range: Select a value between -24 and 0, in steps of 1 dB.
Example: xConfiguration Audio Output HDMI 1 Level: 0
xConfiguration Audio Output HDMI [1..2] Mode
Determine if the audio channel on the HDMI output connector shall be enabled.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the audio channel on the HDMI output.
On: Enable the audio channel on the HDMI output.
Example: xConfiguration Audio Output HDMI 1 Mode: On
xConfiguration Audio Output Line [1..6] Channel
Define whether the Audio Line output is a mono signal or part of a multichannel signal.
Requires user role: ADMIN
Value space: <Right/Left/Mono>
Right: The Audio Line output signal is the right channel of a stereo signal.
Left: The Audio Line output signal is the left channel of a stereo signal.
Mono: The Audio Line output signal is a mono signal.
Example: xConfiguration Audio Output Line 1 Channel: left
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration xConfiguration
xConfiguration Audio Output Line [1..6] Equalizer ID
xConfiguration Audio Output Line [1..6] Equalizer Mode
xConfiguration Audio Output Line [1..6] Level
xConfiguration Audio Output Line [1..6] Mode
34
xCommand
Select the audio output line equalizer ID.
Requires user role: ADMIN
Value space: <1..8>
Range: Select EqualizerID 1 to 8.
Example: xConfiguration Audio Output Line 1 Equalizer ID: 1
Set the audio output line equalizer mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: No equalizer.
On: Enable the equalizer for the audio output line.
Example: xConfiguration Audio Output Line 1 Equalizer Mode: Off
Define the audio level on the line output connector.
See the Audio Level table in the Physical Interface Guide for the codec for a complete overview of
the menu values represented in dB.
Requires user role: ADMIN
Value space: <-24..0>
Range: Select a value between -24 and 0, in steps of 1 dB.
Example: xConfiguration Audio Output Line 1 Level: -10
Set the audio output line mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the Audio Line output.
On: Enable the Audio Line output.
Example: xConfiguration Audio Output Line 1 Mode: On
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.