Logging Configuration - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction

Logging configuration

xConfiguration Logging Mode
Not applicable in this version.
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration xConfiguration
Network configuration
xConfiguration Network [1..1] IPStack
xConfiguration Network [1..1] IPv4 Assignment
xConfiguration Network [1..1] IPv4 Address
48
xCommand
Select if the system should use IPv4, IPv6, or dual IP stack, on the network interface. NOTE: After
changing this setting you may have to wait up to 30 seconds before it takes effect.
Requires user role: ADMIN
Value space: <Dual/IPv4/IPv6>
Dual: When set to Dual, the network interface can operate on both IP versions at the same time,
and can have both an IPv4 and an IPv6 address at the same time.
IPv4: When set to IPv4, the system will use IPv4 on the network interface.
IPv6: When set to IPv6, the system will use IPv6 on the network interface.
Example: xConfiguration Network 1 IPStack: Dual
Define how the system will obtain its IPv4 address, subnet mask and gateway address. This setting
only applies to systems on IPv4 networks.
Requires user role: ADMIN
Value space: <Static/DHCP>
Static: The addresses must be configured manually using the Network IPv4 Address, Network
IPv4 Gateway and Network IPv4 SubnetMask settings (static addresses).
DHCP: The system addresses are automatically assigned by the DHCP server.
Example: xConfiguration Network 1 IPv4 Assignment: DHCP
Enter the static IPv4 network address for the system. This setting is only applicable when Network
Assignment is set to Static.
Requires user role: ADMIN
Value space: <S: 0, 64>
Format: A valid IPv4 address.
Example: xConfiguration Network 1 IPv4 Address: "192.0.2.2"
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.