Xcommand Userinterface Message Textline Display; Usermanagement Commands; Xcommand Usermanagement Remotesupportuser Create; Xcommand Usermanagement Remotesupportuser Delete - Cisco TelePresence MX700 Reference Manual

Cisco TelePresence MX700 and MX800

Introduction

xCommand UserInterface Message TextLine Display

Display a text line on screen. Optionally you can place the text line at a specified location and
for a specified duration of time (in seconds).
NOTE: If Duration is not set, the command must be followed by xCommand Message TextLine
Clear.
Requires user role: ADMIN
USAGE:
xCommand UserInterface Message TextLine Display Text: "Text" [X: X] [Y: Y]
[Duration: Duration]
where
Text: String (0, 140)
Enter the text line to be displayed. The <p> and <br> HTML tags will result in line breaks
as normal; any other tags will appear as plain text.
X: Integer (1..10000)
Enter the X-coordinate (horizontal) on screen. X=0 is in the upper left corner.
Y: Integer (1..10000)
Enter the Y-coordinate (vertical) on screen. Y=0 is in the upper left corner.
Duration: Integer (0..3600)
Set how long (in seconds) the text line is to be displayed on the screen. If set to 0 (zero)
the text line is displayed until a xCommand Message TextLine Clear command has been
sent.
Cisco TelePresence MX700 and MX800 API Reference Guide CE8.0, FEBRUARY 2016.
D15335.02
About the API xConfiguration xCommand xCommand

UserManagement commands

xCommand UserManagement RemoteSupportUser Create

Create a remote support user passphrase that Technical Assistance Center (TAC) can use to
access the system for troubleshooting.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser Create [ExpiryDays: ExpiryDays]
where
ExpiryDays: Integer (1..31)
Define the duration for the passphrase validity. Default is 7 days.

xCommand UserManagement RemoteSupportUser Delete

Delete the remote support user created with the command xCommand UserManagement
RemoteSupportUser Create.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser Delete

xCommand UserManagement RemoteSupportUser DisablePermanently

Disable the creation of new remote support users. To enable the remote support user again you
must factory reset your system.
Requires user role: ADMIN
USAGE:
xCommand UserManagement RemoteSupportUser DisablePermanently Confirm:
where
Confirm: Yes
124
API Reference Guide
xStatus Appendices
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Confirm