Video Commands - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction
xCommand UserManagement RemoteSupportUser GetState
Retrieves the state of the generated remote support user, if one exists.
Requires user role: ADMIN
Example:
xCommand UserManagement RemoteSupportUser GetState
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration

Video commands

xCommand Video AutoPresentationStart Disable
xCommand Video AutoPresentationStart Enable
xCommand Video Input SetMainVideoSource
132
xCommand xCommand
Not in use in this software version.
Requires user role: ADMIN
Example:
xCommand Video AutoPresentationStart Disable
Not in use in this software version.
Requires user role: ADMIN
Example:
xCommand Video AutoPresentationStart Enable
Set which input source is the main video source. You can identify the source either by the identifier
of the connector that it is connected to; or by the identifier of the source itself.
This command requires the use of one, and only one, of these parameters: ConnectorId or
SourceId.
ConnectorId: The identifier (ID) of the connector. Connector [n] has ID n. Run the following API
command to find the ID: xStatus Video Input Connector. The connector ID is also printed on the
codec connector panel.
SourceId: The identifier (ID) of the input source. Input Source [n] has ID n. Run the following API
command to find the ID: xStatus Video Input Source.
Requires user role: USER
Parameters:
ConnectorId: <1..5>
SourceId: <1..4>
Example:
xCommand Video Input SetMainVideoSource ConnectorId: 1
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.