Standby Commands - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction
xCommand Security Persistency
Set the following features to persistent or non-persistent mode. In non-persistent mode the infor-
mation gathered by the specified feature does not persist a reboot of the system. Persistent mode
is the default. This command reboots the system.
Configuration: In non-persistent mode, all configurations are set back to default when the system
reboots.
CallHistory: In non-persistent mode call history is deleted when the system reboots.
InternalLogging: In non-persistent mode eventlog is deleted when the system reboots.
LocalPhonebook: In non-persistent mode local phone book is deleted when the system reboots.
DHCP: In non-persistent mode all IP related information is deleted when the system reboots.
ConfirmandReboot: Reboots the system.
Requires user role: ADMIN
Parameters:
Configurations(r): <NonPersistent/Persistent>
CallHistory(r): <NonPersistent/Persistent>
InternalLogging(r): <NonPersistent/Persistent>
LocalPhonebook(r): <NonPersistent/Persistent>
DHCP(r): <NonPersistent/Persistent>
ConfirmAndReboot(r): <Yes>
Example:
xCommand Security Persistency Configurations: Persistent CallHistory:
Persistent InternalLogging: Persistent LocalPhonebook: Persistent DHCP:
Persistent ConfirmAndReboot: Yes
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration

Standby commands

xCommand Standby Activate
xCommand Standby Deactivate
xCommand Standby ResetTimer
127
xCommand xCommand
Set the system in standby mode, which turns off the video outputs and put the camera into sleep
mode.
Requires user role: USER
Example:
xCommand Standby Activate
Bring the system out of standby mode.
Requires user role: USER
Example:
xCommand Standby Deactivate
Set a temporary standby delay (in minutes). If the system is in standby mode when the reset timer
is set, the system is brought out of standby mode. When left idle for the given delay the system
goes into standby mode. Setting the reset timer does not affect the Standby Delay in the Advanced
configuration menu (or by xConfiguration Standby Delay). Next time this delay is the valid standby
delay.
Requires user role: USER
Parameters:
Delay(r): <1..480>
Example:
xCommand Standby ResetTimer Delay:10
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.