Security Commands - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction
xCommand Provisioning PostponeUpgrade
Postpones the installing of the software upgrade.
Requires user role: USER
Parameters:
SecondsToPostpone(r): <0..65534>
Example:
xCommand Provisioning PostponeUpgrade SecondsToPostpone: 60
xCommand Provisioning StartUpgrade
The codec software can be upgraded from the provisioning server. When starting the upgrade the
software is automatically downloaded and installed. The codec reboots to complete the software
upgrade.
Requires user role: ADMIN
Example:
xCommand Provisioning StartUpgrade
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration

Security commands

xCommand Security FIPSMode Activate
126
xCommand xCommand
Activate FIPS (140-2) mode. NOTE: Activating FIPS mode implies a reset to factory defaults.
While in FIPS mode, software upgrade is disabled and the following limitations apply: All calls are
encrypted, unencrypted communication protocols like Telnet and HTTP cannot be used. IEEE802.1x
and SNMP are disabled. The SIP Profile Type setting cannot be Microsoft. The remote support user
is not available.
To exit FIPS mode, perform a factory reset.
Confirm: <Yes>
Requires user role: ADMIN
Parameters:
Confirm(r): <Yes>
Example:
xCommand Security FIPSMode Activate Confirm: "Yes"
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.