Cisco TelePresence SX80 Reference Manual page 89

Cisco TelePresence SX80
Contents Introduction
*r AudioEqualizerListResult Equalizer 1 Section 4 Q: "4"
*r AudioEqualizerListResult Equalizer 1 Section 4 Gain: "0"
*r AudioEqualizerListResult Equalizer 1 Section 5 FilterType: "Peaking"
*r AudioEqualizerListResult Equalizer 1 Section 5 Frequency: "2000"
*r AudioEqualizerListResult Equalizer 1 Section 5 Q: "4"
*r AudioEqualizerListResult Equalizer 1 Section 5 Gain: "0"
*r AudioEqualizerListResult Equalizer 1 Section 6 FilterType: "Peaking"
*r AudioEqualizerListResult Equalizer 1 Section 6 Frequency: "5000"
*r AudioEqualizerListResult Equalizer 1 Section 6 Q: "0"
*r AudioEqualizerListResult Equalizer 1 Section 6 Gain: "0"
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration
xCommand Audio LocalInput Add
89
xCommand xCommand
Create a local input and generate the local input id. A local input is a mix of input connectors with
the following settings: Name, MixerMode, AGC, Mute and Channels.
This command is mainly intended for internal use by the TC console. TC console automatically
generates a start-up script that makes the command persistent over a reboot. To use this command
outside of TC console, you have to include it in a start-up script in order to make the setting persis-
tent over a reboot. For more information on star-up scripts and TC console see the administrator
guide for your codec.
InputId: A unique identifier for the local input.
Name: Choose a name that describes the mix of input connectors.
MixerMode Auto: The microphone with the strongest speaker is active and the others are strongly
attenuated.
MixerMode Fixed: The input connector signals are mixed together with equal gains.
MixerMode GainShared: The microphones are given a normalized gain factor relative to the stron-
gest speaker before being mixed together.
AGC: Automatic Gain Control.
Mute: Mutes the mix of input connectors.
Channels: Set channels to 1 to mix the input connectors into a mono signal. To mix the input
connectors into a stereo signal, set channels to 2.
Requires user role: ADMIN
Parameters:
InputId: <0..65534>
Name: <S: 0, 255>
MixerMode: <Auto/Fixed/GainShared>
AGC: <On/Off>
Mute: <On/Off>
Channels: <1..2>
Example:
xCommand Audio LocalInput Add InputId: 2
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.