Cisco TelePresence SX80
Contents
Introduction
Translating from terminal mode to XML
Translating commands
The XML commands maintain the same structure as the
terminal commands, but they use a parent-child relationship
to describe the hierarchy. You can see this structure in the
examples below.
Example 1: Setting up a call.
Terminal
xCommand Dial Number: "12345" Protocol: H323
XML
<Command>
<Dial command="True">
<Number>12345</Number>
<Protocol>H323</Protocol>
</Dial>
</Command>
Example 2: Assigning video layout to a call.
Terminal
xCommand Video Layout AssignCall CallId: 2
LayoutId: 1
XML
<Command>
<Video>
<Layout>
<AssignCall command="True">
<CallId>2</CallId>
<LayoutId>1</LayoutId>
</AssignCall>
</Layout>
</Video>
</Command>
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API
About the API
xConfiguration
Translating configurations
Translating from xConfiguration to XML is similar to commands,
but with the addition of a special attribute item="NN" for
specifying the index in arrays.
Example: Configuring the input source type for video
input connector 2.
Terminal
xConfiguration Video Input Connector 2
InputSourceType: camera
XML
<Configuration>
<Video>
<Input>
<Connector item="2">
<InputSourceType>camera</InputSourceType>
</Connector>
</Input>
</Video>
</Configuration>
23
xCommand
xStatus
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
API Reference Guide
Appendices