Cisco TelePresence SX80 Reference Manual page 105

Cisco TelePresence SX80
Contents Introduction
xCommand Camera Preset Remove
Remove a camera preset.
Note that the xCommand Camera Preset commands applies to an individual camera. This is in
contrast to the xCommand Preset commands where a single preset covers ALL connected cameras
plus the Video Input switcher settings.
PresetId: The ID of the camera preset you want to remove.
Requires user role: USER
Parameters:
PresetId(r): <1..35>
Example:
xCommand Camera Preset Remove PresetId: 1
xCommand Camera Preset Snapshot Get
Retrieve a stored snapshot image to illustrate a camera preset.
PresetId: Preset id for the snapshot.
Requires user role: USER
Parameters:
PresetId(r): <1..35>
Example:
xCommand Camera Preset Snapshot Get PresetId:1
xCommand Camera Preset Snapshot Remove
Remove a stored snapshot.
PresetId: Preset id for the snapshot.
Requires user role: ADMIN
Parameters:
PresetId(r): <1..35>
Example:
xCommand Camera Preset Snapshot Remove PresetId:1
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration
xCommand Camera Preset Snapshot Store
xCommand Camera Preset Store
105
xCommand xCommand
Store a new snapshot. This command can only be used if snapshots are enabled with xConfigura-
tion Video AllowWebSnapshots.
PresetId: Preset id for the snapshot.
Requires user role: ADMIN
Parameters:
PresetId(r): <1..35>
Example:
xCommand Camera Preset Snapshot Store PresetId:1
Store the current position (pan and tilt), zoom and focus of the chosen camera. The camera is
identified by the CameraId parameter.
Note that the xCommand Camera Preset commands applies to an individual camera. This is in
contrast to the xCommand Preset commands where a single preset covers ALL connected cameras
plus the Video Input switcher settings. The xCommand Camera Preset commands are useful when
you want to handle multiple camera positions individually per camera, rather than working with
complete sets of camera positions. The individual camera presets are not available for far end
control.
PresetId: The ID of this camera preset. If not set explicitly, the codec will assign a preset ID
automatically.
CameraId: Which camera to store the position of.
ListPosition: The new camera preset's position in the list returned by the xCommand Camera Preset
List command.
Name: The name of the new camera preset. It will be used in the list returned by the xCommand
Camera Preset List command.
TakeSnapshot: Allow or disallow snapshot of the preview.
Requires user role: USER
Parameters:
PresetId: <1..35>
CameraId (r): <1..7>
ListPosition: <1..35>
Name: <S: 0, 255>
TakeSnapshot; <False/True>
Example:
xCommand Camera Preset Store PresetId: 1 CameraId: 1 ListPosition: 1
Name: ""
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.