What's New In This Version - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction Introduction

What's new in this version

This section provides an overview of the new and
changed system settings and new features in the TC7.3
software version.
Software release notes
For a complete overview of new features and changes,
we recommend reading the Software Release Notes
(TC7). Go to:
http://www.cisco.com/c/en/us/support/collabo-
ration-endpoints/telepresence-quick-set-series/
products-release-notes-list.html
Software download
For software download go to:
http://www.cisco.com/cisco/software/navigator.html
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration
New features and improvements
Local preview of presentation in a call
This allows the user to preview the presentation locally
before sharing it with far end. The feature has previously
been available for EX systems, and is now available across
the portfolio.
Multiple presentation outside a call
When the system is not in a call, it can simultaneously
display multiple external sources on the connected
screens, for example from two laptops.
Feature updates
Several feature improvements have been added to better
align with C series functionality. There is now support for:
• H323 / SIP dual registration
• MultiWay
• Additional audio call
Snap to Whiteboard feature
It is possible to configure a set up for a whiteboard
scenario when using the SpeakerTrack 60.
When the system detects a person speaking close to a
whiteboard, the camera will go to a pre-defined preset
covering the whiteboard area as defined by the administra-
tor or installer.
There is a setup wizard for the Snap to Whiteboard feature
in the administrator settings on the Touch 10.
6
xCommand xStatus
TC7.3.0-TC7.3.2: Users are notified when snapshots
are taken
Both the on screen display and web interface have
warnings when the snapshots feature is enabled. A notifi-
cation pops up on the on screen display, when a snapshot
is taken. On the web interface the administrator is warned
that this notice will show up when the feature is enabled.
The system also logs when snapshots are taken, and which
IP address the request was initiated from.
It is possible to allow and disallow snapshots remotely, but
not to observe the room without the users being notified.
TC7.3.3 and later: Remote Monitoring option key
Due to security reasons, taking snapshots of local and
far end video streams from the call control page on the
system's web interface now requires an option key to be
installed on the endpoint.
The remote monitoring option key can only be added to
systems that are upgraded to TC7.3.3 and above. Remote
monitoring is enabled once the option key is added, and
the system rebooted. Once this feature is enabled, the only
way to disable it is to remove the option key.
This feature does not display warning messages or indica-
tors on the local system that someone is monitoring the
room. Please provide adequate notice to users of the
system that the system administrator may monitor and
control the camera and screen.
TC7.3.4 and later: Setting an administrator password
The xCommand SystemUnit AdminPassword Set command
will now change the password of the authenticated user
(granted it has administrator rights).
In previous software versions, this command changed the
password for the default user account (admin).
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
API Reference Guide
Appendices