Cisco TelePresence SX80 Reference Manual page 96

Cisco TelePresence SX80
Contents Introduction
xCommand Audio Volume Decrease
Decrease the volume on the endpoint.
Requires user role: USER
Parameters:
Steps: <1..10>
Example:
xCommand Audio Volume Decrease Steps:3
xCommand Audio Volume Increase
Increase the volume on the endpoint.
Requires user role: USER
Parameters:
Steps: <1..10>
Example:
xCommand Audio Volume Increase Steps:3
xCommand Audio Volume Mute
Mute the volume on the endpoint.
Requires user role: USER
Example:
xCommand Audio Volume Mute
xCommand Audio Volume Set
Set the volume on the endpoint to a specified level.
Requires user role: USER
Parameters:
Level(r): <1..100>
Example:
xCommand Audio Volume Set Level:30
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration
xCommand Audio Volume SetToDefault
xCommand Audio Volume UnMute
xCommand Audio VUMeter Start
96
xCommand xCommand
Set the current volume level as the default for the endpoint.
Requires user role: USER
Example:
xCommand Audio Volume SetToDefault
Unmute the volume on the endpoint.
Requires user role: USER
Example:
xCommand Audio Volume SetToDefault
Start collecting VU meter information for the connector identified by the ConnectorId and
ConnectorType parameters. Together these parameters identify the connector.
ConnectorId: The connector identifier is printed on the codec connector panel.
ConnectorType: Identifies whether it is an HDMI input connector, an audio line input connector or a
microphone connector.
Requires user role: USER
Parameters:
ConnectorType(r): <HDMI/Line/Microphone>
ConnectorId(r): <1..8>
Example:
xCommand Audio VUMeter Start ConnectorType: Microphone ConnectorId: 1
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.